FillExtrusionLayer

Whether this layer is displayed.

The height with which to extrude the base of this layer. Must be less than or equal to fill-extrusion-height.

Transition options for fillExtrusionBase.

The base color of the extruded fill. The extrusion’s surfaces will be shaded differently based on this color in combination with the root light settings. If this color is specified as rgba with an alpha component, the alpha component will be ignored; use fill-extrusion-opacity to set layer opacity.

Transition options for fillExtrusionColor.

The height with which to extrude this layer.

Transition options for fillExtrusionHeight.

The opacity of the entire fill extrusion layer. This is rendered on a per-layer, not per-feature, basis, and data-driven styling is not available.

Transition options for fillExtrusionOpacity.

Name of image in sprite to use for drawing images on extruded fills. For seamless patterns, image width and height must be a factor of two (2, 4, 8, …, 512). Note that zoom-dependent expressions will be evaluated only at integer zoom levels.

Transition options for fillExtrusionPattern.

The geometry’s offset. Values are [x, y] where negatives indicate left and up (on the flat plane), respectively.

Transition options for fillExtrusionTranslate.

Controls the frame of reference for fill-extrusion-translate.

Whether to apply a vertical gradient to the sides of a fill-extrusion layer. If true, sides will be shaded slightly darker farther down.

Undocumented