-
-
-
-
-
-
-
-
Whether this layer is displayed.
-
Controls the intensity of shading near ground and concave angles between walls. Default value 0.0 disables ambient occlusion and values around 0.3 provide the most plausible results for buildings.
-
Transition options for
fillExtrusionAmbientOcclusionIntensity
. -
Shades area near ground and concave angles between walls where the radius defines only vertical impact. Default value 3.0 corresponds to height of one floor and brings the most plausible results for buildings.
-
Transition options for
fillExtrusionAmbientOcclusionRadius
. -
The height with which to extrude the base of this layer. Must be less than or equal to
fill-extrusion-height
. -
Transition options for
fillExtrusionBase
. -
The base color of the extruded fill. The extrusion’s surfaces will be shaded differently based on this color in combination with the root
light
settings. If this color is specified asrgba
with an alpha component, the alpha component will be ignored; usefill-extrusion-opacity
to set layer opacity. -
Transition options for
fillExtrusionColor
. -
The height with which to extrude this layer.
-
Transition options for
fillExtrusionHeight
. -
The opacity of the entire fill extrusion layer. This is rendered on a per-layer, not per-feature, basis, and data-driven styling is not available.
-
Transition options for
fillExtrusionOpacity
. -
Name of image in sprite to use for drawing images on extruded fills. For seamless patterns, image width and height must be a factor of two (2, 4, 8, …, 512). Note that zoom-dependent expressions will be evaluated only at integer zoom levels.
-
Transition options for
fillExtrusionPattern
. -
The geometry’s offset. Values are [x, y] where negatives indicate left and up (on the flat plane), respectively.
-
Transition options for
fillExtrusionTranslate
. -
Controls the frame of reference for
fill-extrusion-translate
. -
Whether to apply a vertical gradient to the sides of a fill-extrusion layer. If true, sides will be shaded slightly darker farther down.
-
-
-