PolylineAnnotationGroupState

The display of line endings.

Specifies the lengths of the alternating dashes and gaps that form the dash pattern. The lengths are later scaled by the line width. To convert a dash length to density-independent pixels, multiply the length by the current line width. Note that GeoJSON sources with lineMetrics: true specified won't render dashed lines to the expected scale. Also note that zoom-dependent expressions will be evaluated only at integer zoom levels. The unit of lineDasharray is in line widths.

Decrease line layer opacity based on occlusion from 3D objects. Value 0 disables occlusion, value 1 means fully occluded.

Controls the intensity of light emitted on the source features. The unit of lineEmissiveStrength is in intensity.

Used to automatically convert miter joins to bevel joins for sharp angles.

Opacity multiplier (multiplies line-opacity value) of the line part that is occluded by 3D objects. Value 0 hides occluded part, value 1 means the same opacity as non-occluded part. The property is not supported when {@link PropertyFactory#lineOpacity} has data-driven styling.

Used to automatically convert round joins to miter joins for shallow angles.

The geometry's offset. Values are x, y where negatives indicate left and up, respectively. The unit of lineTranslate is in density-independent pixels.

Controls the frame of reference for {@link PropertyFactory#lineTranslate}.

The line part between trim-start, trim-end will be marked as transparent to make a route vanishing effect. The line trim-off offset is based on the whole line range 0.0, 1.0.